35340-2G710 55PP41-01 Fuel Pressure Switch Sensor for Kia Optima Sorento Sportage Hyundai Sonata Tucson Santa Fe 2.0L 2.4L 10-15

Product SpecificationsPart Numbers: 35340-2G710, 353402G710, 35340-26710, 3534026710, 55PP41-01, 55PP4101Sensor Type: Piezoresistive fuel rail pressure sensorSupply Voltage: 5V DC from ECUOutput Signal: Analog 0.5V - 4.5V (linear with pressure)Pressure Range: 0 - 20 MPa (0 - 200 Bar / 0 - 2900 PSI) for GDI systemsThread Size: M12 x 1.25 or M14 x 1.5 (verify on your vehicle)Connector Type: 3-pin sealed (5V supply, signal ground, pressure output)Seal Type: O-ring (included with sensor)For Hyundai Fitment ChartModelYearsEngineFor Hyundai Santa Fe2013, 2014, 2015, 20162.0L / 2.4L GDIFor Hyundai Sonata2011, 2012, 2013, 20142.0L / 2.4L GDIFor Hyundai Tucson2013, 2014, 20152.0L / 2.4L GDIFor Kia Fitment ChartModelYearsEngineFor Kia Optima2011, 2012, 2013, 2014, 20152.0L / 2.4L GDIFor Kia Sorento2011, 2012, 2013, 2014, 20152.0L / 2.4L GDIFor Kia Sportage2011, 2012, 2013, 2014, 2015, 20162.0L / 2.4L GDICritical Usage NoteThis fuel rail pressure sensor is designed for 2.0L and 2.4L GDI (Gasoline Direct Injection) engines only. Not compatible with 1.6L turbo, 2.0L turbo (Theta II), 3.3L V6, or 3.8L V6 engines. For Hyundai Sonata or for Kia Optima has a turbocharger, verify the fuel rail sensor part number before ordering. The 35340-2G710 sensor is specific to naturally aspirated GDI engines.

• 📋 Part Number Verification - Fuel rail pressure sensor replaces OEM numbers 35340-2G710, 353402G710, 35340-26710, 3534026710, and 55PP41-01 (also 55PP4101). Before ordering the 35340-2G710 fuel pressure sensor for Hyundai or for Kia, verify your old sensor matches one of these numbers. The 55PP41-01 sensor cross-references directly to the OEM for Hyundai/for Kia part.
• 🚗 For Hyundai Model Fitment - 35340-2G710 pressure sensor fits: 2013-2016 for Hyundai Santa Fe (2.0L/2.4L), 2011-2014 for Hyundai Sonata (2.0L/2.4L), and 2013-2015 for Hyundai Tucson (2.0L/2.4L). The fuel rail pressure sensor mounts directly to the fuel rail on GDI engines. Confirm your engine size - this 55PP41-01 sensor is for 2.0L and 2.4L 4-cylinder models only.
• 🚙 For Kia Model Fitment - 55PP41-01 fuel pressure sensor fits: 2011-2015 for Kia Optima (2.0L/2.4L), 2011-2015 for Kia Sorento (2.0L/2.4L), and 2011-2016 for Kia Sportage (2.0L/2.4L). The 35340-2G710 fuel rail sensor is not compatible with V6 engines or turbo models without verifying fitment. Check your engine code before ordering this pressure switch sensor.
• ⚠️ Symptoms of a Bad Sensor - For Hyundai Sonata shows check engine light with codes P0190, P0191, P0192, or P0193, test this 35340-2G710 fuel pressure sensor. A failed fuel rail pressure sensor causes hard starting, poor acceleration, reduced fuel economy, or engine stalling. The ECU may enter limp mode when it receives incorrect pressure readings from a bad 55PP41-01 sensor. Replace immediately to prevent catalytic converter damage from incorrect fuel trims.
• 🔧 Installation Notes - This 35340-2G710 fuel pressure sensor uses a 19mm or 22mm wrench (verify on your vehicle). The sensor mounts on the fuel rail with an O-ring seal. Relieve fuel system pressure before removal. Do not use thread sealant - the O-ring provides the seal. Torque to 15-20 Nm (133-177 in-lbs). After installing this 55PP41-01 fuel rail pressure sensor for Kia Sportage or for Hyundai Tucson, clear fault codes with an OBD2 scanner before test driving.